Buoyancy you can control.

A helium envelope sets the lift, a ballonet inside it changes the vehicle's density, and a hinged arm shows the result.

Try it

Inflate the ballonet.

Drag the slider. The ballonet fills with ambient air, buoyancy shifts, and the arm lifts the aerobot, up to 15–20 cm. The numbers come from the proposal's design values.

0.0L
Arm angle
0°
Rise vs gondola
0.0cm
Buoyancy change
0.00g

Deflated · arm at 0°

Illustrative and not to scale in time. The real arm response is exactly what the flight will measure.

The system

Five parts, one measurement.

Helium, sealed

A thermoplastic polyurethane (TPU) envelope, nominally 50 cm across at float. No gas is exchanged in this volume during operations. The helium fill is sized to allow for expansion on ascent.

Air, adjustable

An inner TPU bag sized for about 10–12 L of ambient air at full inflation. It inflates and deflates to change the aerobot's relative density.

On the beam

A volumetric pump feeds ambient air to the ballonet. It sits on the fixed beam, which keeps mass and vibration off the moving arm.

A 50 cm beam, a hinged arm

A fixed beam leaves the gondola. At two-thirds of its length a 15–20 cm arm swings from 0° to 90°. A precision actuator at the hinge cancels the dry mass, because lift at float is only about 3 g.

Inside the gondola

The flight computer and data acquisition system sit in the main experiment module, protected from the stratosphere. All power comes from the BEXUS gondola supply.

Venting and restraint

The ballonet venting method and the arm restraint for launch and descent are not yet defined. We will publish them once designed and tested.

Measurements

What we record, and how.

QuantitySensorWhy
Arm angleRotary or magnetic encoderConverts to the aerobot's displacement relative to the gondola.
PressureBallonet · helium · ambientDifferential pressure between injected air, helium and the atmosphere.
TemperatureThermocouples or RTDsThermal gradients across air, helium and ambient, especially at the tropopause where temperatures can fall below −80 °C.
MotionNine-axis IMUsOne on the gondola, one on the aerobot, to separate disturbances from the control response.
Safety by design

An arm that can never become a hazard.

The gondola is shared with other experiments, so the external arm is designed to fail safe.

  • Sacrificial jointThe arm yields or decouples on a hard landing, protecting the gondola and neighbouring experiments.
  • Safety tetherSecures the arm to the gondola frame so nothing becomes an untethered hazard.
  • 0° restraintHolds the arm during pre-launch handling, ascent and descent. Mechanism still to be designed.
  • 90° hard stopStops the arm from swinging past vertical toward the gondola, other experiments or the suspension cables.
  • Load testsStructural and load tests before flight for up to 10 g at parachute opening and landing loads.
3.3kg + 1.2 kg margin
Preliminary mass: 0.80 kg inside the gondola, 2.50 kg outside, before margin
34Wh
Working energy allowance, about 1.2 Ah at 28.8 V, including a 20% margin
4–5kB/s
Planned downlink for both IMUs and all other channels
0.85 × 0.60 × 0.75m
External operating envelope: reach, width and height above the beam
1.2A
Planned current limit on the pump motor controller, against over 10 A unlimited inrush
Top or bottomrail
Mounting on the gondola's structural rail, clear of the suspension straps